Refrigerators

1. Empty and dry out the inside of the refrigerator.
2. Keep door open for air circulation to keep the cavity dry.
3. Install storage lock if provided.
4. Remove battery from coach.
5. Disconnect solar panel from electrical system.
6. Disconnect shore power from coach.
7. If you don't follow these steps and the refrigerator may not operate resulting in the need to perform a hard reset.

Click here to watch the video

No

1. Remove the unit (RV) from shore power (120 VAC).
2. Disconnect the battery's negative terminal (12 VDC).
3. Disconnect the solar system in the unit (RV) (12 VDC).
4. Wait 5-10 minutes.
5. Restore Power.
NOTE: Using a battery disconnect in place of disconnecting the battery's negative terminal is not sufficient for disconnecting the battery, because the refrigerator may be directly connected to the battery. Click here to watch the video

10.2~14.2V DC dedicated single branch.

Refrigerator will need to be replaced.

Fuse can be found at the bottom of the refrigerator. Newer models can be found behind the front panel. Older models can be found at the back of the refrigerator.

Click here to watch the video

1. Verify refrigerator and unit is level
2. Door could have been reversed and not properly installed
3. Inspect seal for damage or dirt
4. Make sure baskets and shelves are seated properly

Click here to watch the video

1. Make Sure Room is Not to Hot - A hot room could cause the refrigerator to continuously cycle.
2. Inspect Seal of Doors on Refrigerator - Open door and inspect seal for damage. Close door and make sure door is fully sealed.
3. Check Battery Level - Make sure battery is fully charged, fully maintained battery. If it drops below 10.5V it may cause intermittent issues.
Click here to watch the video

This is normal, you are hearing the circulation of the refrigerant of the appliance

Click here to watch the video

This is normal, metal parts in the refrigerator expand and contract like hot water pipes

Click here to watch the video

1. Turn of refrigerator. Wait 10-15 minutes and turn back on.
2. Use a cup of water to test operation.
3. Perform Hard reset. Remove the unit (RV) from shore power (120 VAC).
4. Disconnect the battery's negative terminal (12 VDC).
5. Disconnect the solar system in the unit (RV) (12 VDC).
6. Wait 5-10 minutes.
7. Restore Power.
NOTE: Using a battery disconnect in place of disconnecting the battery's negative terminal is not sufficient for disconnecting the battery, because the refrigerator may be directly connected to the battery.
8. Test for operation.
9. Remove refrigerator from opening.
10. Inspect wiring connections, repair as needed.
11. Remove rear panel and inspect for refrigerant leak. If leak is found replace refrigerator.
12. Inspect fuse condition and replace as needed.
13. Perform bench test by connecting directly to a fully charged and maintained battery. If it still doesn't cool, replace refrigerator.

Click here to watch the video

1. Confirm refrigerator has proper power with a fully charged fully maintained battery.
2. Make sure controls are on and set at the proper temperature.
3. Inspect seals for damage and confirm that they fully seal when door is closed.
4. Confirm all vents in refrigerator are not blocked.

Click here to watch the video

1.Open door and check the setting. If it is set to max these noises are normal.
2. Make sure refrigerator and unit is level.

Click here to watch the video

1. Make sure door is closed and fully sealed.
2. Control could be set to cold for the environment you are in.

Click here to watch the video